APRILIA SL 750 SHIVER Specifications download pdf (Page 75)

TABLE O - GROUND LEAD AND START-UP

CABLE

1. Direct the cable as shown in figure.

2. Before fitting the cable, push the sheath to

the panel terminal so as to hide the RED ca-

ble (see box).

3. Fasten the cable with a clamp 10-mm (0.39

in) long.

TABLE P - GROUND LEAD AND START-UP CA-

BLE

1. Fasten the cable with clamps where indica-

ted.

2. Be careful not to hold the MAP sensor

pipe with the clamp.

3. Place the cable harness as shown.

Back side

CAUTION

ONCE THE ELECTRICAL SYSTEM IS REFITTED, THE CONNECTORS RECONNECTED AND

CLAMPS AND RETAINERS RESTORED, CARRY OUT THE CHECKS INDICATED UNDER "SPE-

CIAL CHECKS FOR THE CORRECT CONNECTION AND LAYING OF CABLES" IN THE "ELEC-

TRICAL SYSTEM INSTALLATION" SECTION.

TABLE A - REAR LIGHT CABLE HARNESS

1. Rear right turn indicator: BLACK and RED cables.

2. Left turn indicator: BLACK and SKY BLUE cables.

3. Fasten the rear light cable harness to the rear frame with two small clamps.

4. When fitting the cable harness, make sure that the cable harness sheathing is visible in the indi-

cated area of the curved support.

SL 750 SHIVER Electrical system

ELE SYS - 17

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 302 303

No comments

APRILIA SL 750 SHIVER Specifications Page 75