APRILIA SL 750 SHIVER Specifications download pdf (Page 127)

•

Clutch pulled: closed circuit (continuity)

•

Clutch released: open circuit (infinite resistance)

Pin-out:

1. Voltage 12V

2. Ground connection

CAUTION

BEFORE CARRYING OUT ANY TROUBLE-

SHOOTING, CAREFULLY READ THE GENER-

AL CONCEPTS OF ELECTRICAL TROUBLE-

SHOOTING FOUND AT THE BEGINNING OF

THE CHECKS AND CONTROLS SECTION IN

THE ELECTRICAL SYSTEM CHAPTER.

AXONE: STATUSES

Clutch

Example value:Indefinite - released - pulled

The statuses regularly viewed are Released / Pulled

Troubleshooting:

•

Indication on Axone always Released: check the correct position of the cable terminals on

the connector and the correct connection of the cables on the terminals. If they are not

correct, restore the cable harness; if correct, disconnect the two terminals from the sensor

and, with key set to ON, check continuity to ground connection of PIN 2: if there is no con-

tinuity, restore the cable harness; if there is, replace the sensor

•

Indication on Axone always Pulled: disconnect the terminals from the sensor and check if

there is continuity between the two PINS, with clutch released: if there is continuity, replace

the sensor. If the circuit is open, it means that the brown/purple cable from sensor PIN 1 to

ENGINE connector PIN 50 is short circuit to ground: restore the cable harness

SL 750 SHIVER Electrical system

ELE SYS - 69

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 302 303

No comments

APRILIA SL 750 SHIVER Specifications Page 127