APRILIA SL 750 SHIVER Specifications download pdf (Page 63)

1. Front section

2. Central section

3. Rear section

SPECIAL CHECKS FOR THE CORRECT CONNECTION AND LAYING OF CABLES

Carry out the checks described below once the electrical system is refitted, connectors recon-

nected and clamps and retainers restored.

•

Check the connector block for connections and correct tightening in the following connec-

tors.

1. Instrument panel connector: FRONT SECTION, TABLE J.

2. Handgrip sensor connectors: CENTRAL SECTION, TABLE F.

3. Pick Up Connector: CENTRAL SECTION, TABLE Q.

4. Side Stand Switch Connector.

5. Regulator Connector: CENTRAL SECTION, TABLE H.

6. Front cylinder coil and rear cylinder coil connectors: CENTRAL SECTION, TABLE F.

7. Filter Housing Connectors: CENTRAL SECTION, TABLE F.

8. ECU and Ground Lead Connectors for the filter casing: CENTRAL SECTION, TABLE A.

9. Fuel Pump Connector: CENTRAL SECTION, TABLE F.

10.Key Connector - Right Light Switch Connectors - Left Light Switch Connectors: Connectors inside

the housing behind the radiator: FRONT SECTION, TABLE I.

•

THE CONNECTORS LISTED ARE CONSIDERED CRITICAL IN COMPARISON WITH

THE OTHERS BECAUSE THE VEHICLE WILL STOP IF THEY ARE ACCIDENTALLY DIS-

CONNECTED.

•

Undoubtedly the connection of the rest of connectors is also important and essential for the

correct operation of the vehicle.

Front side

CAUTION

ONCE THE ELECTRICAL SYSTEM IS REFITTED, THE CONNECTORS RECONNECTED AND

CLAMPS AND RETAINERS RESTORED, CARRY OUT THE CHECKS INDICATED UNDER "SPE-

CIAL CHECKS FOR THE CORRECT CONNECTION AND LAYING OF CABLES" IN THE "ELEC-

TRICAL SYSTEM INSTALLATION" SECTION.

SL 750 SHIVER Electrical system

ELE SYS - 5

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 302 303

No comments

APRILIA SL 750 SHIVER Specifications Page 63