LUBRICATION
3 - 88
En
ine 450 - 550
GEARBOX SECONDARY SHAFT BEARING
REMOVAL
• Remove bearing retaining screws and relevant plate.
• Remove the circlip.
• Working on crankcase external side, remove oil seal,
heat crankcase and remove the bearing using an
internal puller.
REASSEMBLY
• Reassemble the bearing using the special tool, part no.
9100885
WARNING
Check that plate adjustable support is fully
home and warm coupling areas of the bearing
properly.
• Refit circlip, plate and relevant screw.
Comments to this Manuals